Godiva Budget Supercar

Project Godiva – Part 10

The past three months have been marked not so much by what construction has occurred, but rather by the number of final – if they are truly final – decisions that have been made. Steering Rack The previously acquired Ford Escort steering rack has been replaced by a Toyota rack. The Escort the rack sat…

Read More

Project Godiva – Part 9

Even with years of planning, actually making Godiva has never really been a very linear process, where each step is well planned in advance and flows smoothly from one stage to another. Instead it has been very much like a long staircase in a grand old building where there are pauses along the way to…

Read More

Project Godiva – Part 8

What you see below is the Mitsubishi drivetrain (engine and transaxle) removed from the car, complete with subframe, suspension, struts and discs etc. What I had not expected when this was finally on my garage floor was that the driveshaft would be approximately 40mm lower than the crankshaft. It was a surprise, mostly because you…

Read More

Project Godiva – Part 7

The basic primary and secondary structures for Godiva have been detailed in the previous two issues of Race Magazine. However I have received quite a few questions of how the honeycomb panels actually attach to the chassis and since there seemed to be such interest I thought that this issue should document my research and…

Read More

Project Godiva – Part 6

Secondary Structure In Issue five, we had a brief look at the proposed hybrid chassis that we intend to use as a basis for Godiva. The chassis proposed uses a simple steel SHS spaceframe stiffened with aluminium honeycomb panels to achieve the desired performance. The chassis described so far is not the complete structure of…

Read More

Project Godiva – Part 5

What you see on the following page is the concept diagram for Godiva’s chassis. You can see that the diagram has ‘layers’ to help make sense of the overall image (note all red/green/black lines are steel tube, coloured sections are honeycomb panel). However, before going into the details as such we should consider the overall…

Read More

Project Godiva – Part 4

What type of engine would you like to use to power your own ‘supercar’? Does the sound and feel of the engine’s power delivery give you a warm glow inside, even after the drive has finished? Do you have a particular allegiance to a brand and type of engine? Do you only want a manual…

Read More

Project Godiva – Part 3

As I said originally I would pay attention to those readers who showed interest in building a ‘Godiva’ of their own. To my surprise the overwhelming request was 95% for a mid/rear engined car and I also admit that it is my current preference as well (note this may have biased some of the reasoning…

Read More

Project Godiva – Part 2

We now need to start discussing some of the design priorities. Where do we start? Basically we have to decide what ‘Godiva’ is to be designed for and what the priorities are. What I see is that Godiva should be able to take a driver and one passenger fast as possible and as safe as…

Read More

Project Godiva – Part 1

Welcome to the first of many (we hope!) articles where we attempt to wade through the issues surrounding the design, construction and race/registration of a Individually Constructed Vehicle (ICV) that can be used at the track and probably on the road as well!

Read More